g741.org

Posted: **Wed Sep 23, 2009 2:14 pm**

GOOD EVENING ALL,
I JUST GOT BACK FORM A HUDSON CANYON CHARTER AND MY NEW LOCKING HUBS WERE DELIVERED. BEFORE I PULL THE CAPS OFF AND INSTALL THE NEW LOCKING HUBS (DON STOCKLEY) ARE THERE ANY SUPRISES I SHOULD BE LOOKING AT? OR JUST REMOVE THE SIX NUTS AND STUDS AND INSTALL THE NEW KIT??
THANKS
BOB

Posted: **Wed Sep 23, 2009 3:56 pm**

sometimes the drive flanges can be a bear to get off when they stick, but, use the puller bolt holes, and give them a few gentle taps and they usualy come right off.

Posted: **Thu Sep 24, 2009 5:44 am**

Put the transfer case in neutral as well, to remove any load from the axle shafts prior to removal.
Gary

Posted: **Fri Sep 25, 2009 2:43 am**

THANKS TO ALL. THE ORIGINAL CAPS CAME RIGHT OFF, NO PROBLEM AND THE NEW LOCKING HUBS FIT PERFECTLY.