Page 1 of 1
Ok I have misplaced where the large ball barring goes in the
Posted: Wed Oct 22, 2008 7:22 pm
by bubba_got_you
Ok I have misplaced where the large ball barring goes in the carburetor. Any one know where it goes or have an exploded view?
Re: Ok I have misplaced where the large ball barring goes in
Posted: Sat Oct 25, 2008 7:55 am
by MSeriesRebuild
bubba_got_you wrote:Ok I have misplaced where the large ball barring goes in the carburetor. Any one know where it goes or have an exploded view?
The only ball bearing in the carb is on the throttle shaft.
Re: Ok I have misplaced where the large ball barring goes in
Posted: Sat Oct 25, 2008 3:08 pm
by bubba_got_you
MSeriesRebuild wrote:bubba_got_you wrote:Ok I have misplaced where the large ball barring goes in the carburetor. Any one know where it goes or have an exploded view?
The only ball bearing in the carb is on the throttle shaft.
I have 3 one small one medium and one large
Posted: Sat Oct 25, 2008 5:14 pm
by MSeriesRebuild
I realized you are talking about something else after reading a post you had on the PWA forum. You are speaking of a ball, not a ball bearing. The large ball goes under the snap ring in the bottom of the pump plunger bore.