Posted: Sun Jan 20, 2008 4:47 pm
yes i know but we are not driving the truck yet, it will get a grommet when the weather warms up and i can get a much larger bit 
Page 2 of 2
Posted: Sun Jan 20, 2008 7:58 pm
For drilling through sheet metal, a metal-cutting hole saw might work better.
Posted: Mon Jan 21, 2008 8:03 am
yeah didn't relize the unibit was to small till it was to late
Posted: Sun Jan 27, 2008 3:28 pm
Hello, And in reading all of these posts for the heater installation, what is this heater from? Is it the correct one for the M37, or an adaption? And did I read that this heater you installed has defrost capacity? Thank You, Peter Mark
Posted: Sun Jan 27, 2008 3:40 pm
it is for a m151 mutt jeep, does have defrost and i saw the defrosters mounted in an m37 but you need to cut holes in the dash looks nice when done but not sure if I want to cut long slots in the dash