Posted: Thu Nov 26, 2009 12:24 pm
How about posting them here in this thread? 
Page 2 of 4
Bracket Drawing
Posted: Thu Nov 26, 2009 1:58 pm
That sounds like a plan, huh Bill?
Posted: Thu Nov 26, 2009 5:37 pm
blank
OT
Posted: Thu Nov 26, 2009 6:13 pm
M-Thrax,M-Thrax wrote:Sure I'll be happy to post them here whats the "FAX" number!!
Sheez!!
Don't you guys think that if I had it on file I would have already posted it here???
If the wife gets the scanner working I'll copy it to file and post it
Did you ever find the MS hardener?
Posted: Thu Nov 26, 2009 6:26 pm
blank
Posted: Fri Dec 04, 2009 6:47 am
Any luck with those drawings?
Posted: Sat Dec 12, 2009 9:58 am
Back to the top... I can make the spotlight mounts for alot less,but I need the drawings.
I can make the spotlight mounts for alot less,but I need the drawings.TTTop
Posted: Mon Dec 14, 2009 8:30 am
How about if I send it to you off the forum, I can't find when I'm looking for? Plus I can't figure out how to get it on my webshots page to load it here?
Posted: Mon Dec 14, 2009 11:55 am
Bruce,
Just scan and email them to me and I'll put them up here.
Just scan and email them to me and I'll put them up here.
What A Hassle
Posted: Mon Dec 14, 2009 2:13 pm
I just sent Chunk the pdf file, he'll let me know if he did or didn't get it, I'm sure. My fingers are freezing from making wreaths! 
Did You Gett'em
Posted: Wed Dec 16, 2009 7:28 pm
I didn't hear from you so I figured I'd check in?Chunk wrote:Email your pictures to me.... gijoem37@sbcglobal.net I'll see if I can post them for you.
Posted: Thu Dec 17, 2009 7:51 am
Merry Christmas Bruce. Show us a wreath
pdf's are a pain
Posted: Thu Dec 17, 2009 9:32 am
Here is the spotlight mount pic's.
Original
Modified I enlarged the specs for easier viewing.
.875 tube diameter/.5 hole size, (.875/.5) are the two measurements on that side...just got crowded.
Big thanks to m-37Bruce for taking the time to send me the file.
Original
Modified I enlarged the specs for easier viewing.
.875 tube diameter/.5 hole size, (.875/.5) are the two measurements on that side...just got crowded.
Big thanks to m-37Bruce for taking the time to send me the file.
Is It Me?
Posted: Thu Dec 17, 2009 2:35 pm
OK, I'm going out on a limb here & I can't take credit for this, it came from Tony Eagling, aka; Da' Monkey Man or MM, our own G-741 Moderator Extraordinaire, circa 2003
BTW, Thanks Captnsim
What's old in new again, Tony I hope you weren't holding this one back? Combat Rims!
BTW, Thanks Captnsim
What's old in new again, Tony I hope you weren't holding this one back? Combat Rims!
Posted: Fri Dec 18, 2009 8:22 am
Thanks for the blue prints Bruce.
WOW what a cool Christmas card
WOW what a cool Christmas card