WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Buy and sell M37 and related stuff

Moderators: Cal_Gary, T. Highway, Monkey Man, robi

Forum rules
Your Location must be included in your advertisement or it may removed without notice.
Post Reply
ashyers
MSGT
MSGT
Posts: 820
Joined: Mon Jan 05, 2015 8:20 pm
Location: Oakland CA

WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Post by ashyers »

Looking for one brass PCV fitting for the fresh air tube that goes from the carb inlet elbow to the oil fill tube. They are also used on the PCV lines that go from the rear of the block to the intake. I'm one short!

It's a 7/16" inverted flare to 1/4 MPT 90 deg.

Thanks,

Andy
just me
1SG
1SG
Posts: 1195
Joined: Fri Nov 28, 2014 4:25 pm

Re: WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Post by just me »

That is a Dorman item and obtainable from a REAL auto parts store.
"It may be ugly, but at least it is slow!"
ashyers
MSGT
MSGT
Posts: 820
Joined: Mon Jan 05, 2015 8:20 pm
Location: Oakland CA

Re: WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Post by ashyers »

just me,
If you can find a P/N I'm all ears! I've had no luck.

Andy
just me
1SG
1SG
Posts: 1195
Joined: Fri Nov 28, 2014 4:25 pm

Re: WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Post by just me »

I used the NSN and could not find one. I checked all my suppliers. Weatherhead, Plews, Parker, etc. Everyone skips 7/16 tube. Unless you can find them used, I'd change tube size or make my own fitting.
"It may be ugly, but at least it is slow!"
ashyers
MSGT
MSGT
Posts: 820
Joined: Mon Jan 05, 2015 8:20 pm
Location: Oakland CA

Re: WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Post by ashyers »

I think I may have located a used one :)!
Tom P
CPL
CPL
Posts: 148
Joined: Sat Oct 20, 2007 4:01 am
Location: Fairview Hts. IL.
Contact:

Re: WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Post by Tom P »

As you found that fitting is no longer made.
Hope your used on works out.
The only other thing to do other than used is to change to
3/8 pipe and fittings.
Tom
"47" WDX WW
"52" M37 WW
"54" Willys M38A1
"65" M35A1 WW
To Many Others
http://www.g741.org/photogallery/main.p ... temId=2019
JBizal
CPL
CPL
Posts: 128
Joined: Sun Oct 28, 2007 3:19 pm

Re: WTB: PCV Fitting, 7/16 Inverted Flare to 1/4 MPT 90 deg

Post by JBizal »

Midwest Military has these.
John
Post Reply